T15h Tag Deployment & User Guide
48
Best Practice Note: It is recommended to inherit the configuration from the
Asset / Category. Only set local conditions when required.
Event Conditions
Configure the Event Conditions according to the following:
Set event condition in absolute terms: If you want to set a specific (not
inherited from the asset / category level) temperature range that triggers an
alert, enter it here.
: Select this
option to use thresholds defined on the asset / category level.
Set trigger time:
Only Trigger after:
a configured range before an Alert is sent. For example; if the time
its configured range,
an alert will be triggered if its value does not normalize within the set time
of 15 min.
Asset default time: Select this option to use the value defined on the Asset
/ Category level.
Alert when no temperature reports have been received for: NOTE: This
option must not be used as it will be removed in a future version. It is
recommended to create a Sensor Tag Error Event instead. See Sensor
Tag Error Event.
Best Practice Note: It is recommended to inherit the configuration from the
Asset / Category. Only set local conditions when required.
Actions
Set the actions accordingly.
To Next Page
Loading...
