Stanton SC System 3 - Channel Fader; Crossfader

Channel Fader
7
3.1.3 Channel Fader
3.1.4 Crossfader
The Channel Faders (also called line faders, upfaders, etc.)
control the volume of their associated channel before the
signal gets to the Crossfader. The touch sensive strips on
the SCS.3m act just like the Channel Faders on a tradional
mixer, allowing you to adjust the volume of the channel.
Like the Crossfader, the Channel Fader on the SCS.3m has
a row of LEDs next to it that will indicate its posion.
(Figure 3.3)
Figure 3.3
MASTER
MASTER
O
1
O
O
1
O
At the boom of the SCS.3m or a tradional mixer, you
will usually find a Crossfader.
The Crossfader is used to mix between sources of your
mixer. Typically, moving the crossfader to the le
transions the audio to channel 1, and full right to channel
2. Anywhere in the middle is a mix of both channels.
As you can see, on the SCS.3m there is not a tradional
fader there to let you know the posion of your crossfader.
Instead, the SCS.3m has a row of LEDs above the
crossfader that will indicate its posion. (Figure 3.4)
Figure 3.4
O
1O
O
1O