Stanton SC System 3 - Installing Virtual DJ le; Configuring for Audio Output

5
Installing Virtual DJ LE/Configuring for Audio Output
2.3 Installing Virtual DJ LE
Windows
Before you can begin using your SCS.3PAK with your computer, you must install the included VirtualDJ
LE soware:
1. Please insert the included Stanton Support disc into your computer's DVD/CD drive.
2. Open the CD to view its contents, Open the folder tled "VIRTUAL DJ", then the folder tled
“WINDOWS” and double-click the ".Msi file".
4. Follow the on-screen instrucons to finish installing.
3. Open VirtualDJ LE by double-clicking the icon on your computer's Desktop (if you created a Desktop
shortcut) or by going to Start : All Programs : VirtualDJ.
For more informaon on how to use VirtualDJ LE, please see the included Quick Start Guide and videos
on your support CD.
OSX
Before you can begin using your SCS.3PAK with your computer, you must install the included VirtualDJ
LE soware:
1. Please insert the included Stanton Support disc into your computer's DVD/CD drive.
2. Open the CD to view its contents, Open the folder tled "VIRTUAL DJ", then the folder tled “OSX”
and double-click the ".PKG file".
4. Follow the on-screen instrucons to finish installing.
5. Open VirtualDJ LE by going to Applicaons : VirtualDJ.
For more informaon on how to use VirtualDJ LE, please see the included Quick Start Guide and videos
on your support CD.
2.4 Configuring Virtual DJ wth the included Audio Cable for headphone/speaker output
The SC System 3 comes with a special audio cable, which can be used in place of a seperate audio
interface.
While we recommend purchasing an external audio interface for professional use, this cable will allow
you to DJ with just the 1/8” mini-plug output from your computer. For serious DJs that already have
one or more audio interfaces, it sll comes in handy as something you can carry around with you as
a backup soluon, and as an easy to use alternave if you’re just sing around building playlists and
don’t want to have a bunch of stuff spread out everywhere.
To use the cable and your onboard soundcard, you’ll need to take a minute to configure Virtual DJ LE.
1. First, plug the cable into the Headphone output on your computer.
2. Then, plug the leads to your stereo, mixer, or powered speakers to the RCA outputs on the
cable. This will be your main output.
3. Next, plug your headphones into the headphone jack on the cable.
Finally, within Virtual DJ LE, under CONFIG->SOUND SETUP, go to OUTPUT and select ‘Headphones’
This will send the appropriate signal (Master/Cue) to your speakers and headphones.