– 17 –
ENGLISH
6-2-2.Loading the Paper
1 Lift the cover up approx. 3 cm. Hold
the cover tilted at this angle, then
pull it toward you to remove it.
2 Cut off the front edge of the roll
paper perpendicularly.
3 Confirm that the power of the printer
is turned on.
4 While observing the direction of the
roll, set the paper roll into the hol-
low as shown in Fig. 6-13.
Fig. 6-12 Removing the cover
Fig. 6-13 Setting the paper
Cover
Roll paper
To Next Page
Loading...
