Software Manual
102
■ Paper width used
The default setting is “80mm (Do Not Compress)”.
By changing the setting to 80mm->58mm, the printing area is compressed widthwise so that 58 mm
width roll paper can be used instead of 80 mm width roll paper.
1) If the printing width is set to 51 mm using General Settings in the configuration utility, the
80mm->58mm setting in Paper width used is disabled.
2) When Paper width used is set to 80mm->58mm, the barcode will be aligned on the left margin
of the paper when printed. If the printed barcode will be wider than 80mm->58mm, the
barcode data will not be printed.
■ Receipt length reduction <TSP100ECO, TSP100IIIU>
The default setting is Original (no reduction).
The printing area can be compressed 50% reduction or 25% reduction lengthwise.
Because the size of printed barcodes is not reduced even if the receipt length reduction settings
are selected, the receipt length will be longer than the length for the reduction ratio when
printing data that contains barcodes.
4.5.2. Top Margin to First Line <TSP100ECO only>
The length from the leading edge of the paper to the first line of printing can be specified.
The default setting is 3mm.
We recommend 3 mm as being effective for the ECO function; however, backward feeding is
carried out for each cut operation when 10 mm or fewer is specified. To reduce the printing time,
set to 11 mm.
To Next Page
Loading...
