Software Manual
171
7.2. Manually Setting an IP Address (Using the TSP100III Telnet Utility)
You can use the telnet command to connect directly to a TSP100IIIW/TSP100IIILAN printer.
■ Begin with the following preliminary steps to ensure that Telnet is enabled.
1. From the [Start] menu, open the [Control Panel].
2. Select [Programs and Features].
3. Under [Tasks], select [Turn Windows features on or off].
4. When the User Account Control dialog appears, click [Continue].
5. If [Telnet Client] is not yet checked, place a check next to it. Then click [OK].
6. If you had to add the check in the previous step (if Telnet Client was not already checked to begin
with), you must now restart your computer.
To Next Page
Loading...
