Star Micronics TSP100IIIU - Print Job Routing (Write Printer) <ESC;POS Mode Only>

Software Manual
163
4.18.Print Job Routing (Write Printer) <ESC/POS Mode Only>
Click the “Write Printer API” tab in the left pane of the window.
When printing in the ESC/POS mode, use one of the following methods.
・ Select the "Enable ESC/POS Routing" checkbox on "Print Job Routing".
・ Specify a serial port in the ESC/POS mode. (Refer to "4.9. Serial Port".)
・ Specify a virtual TCP/IP port in the ESC/POS mode. (Refer to "4.18. Virtual TCP/IP Port".)
If the "Enable ESC/POS Routing" checkbox is not selected while any serial port or virtual TCP/IP port is not
specified, data is printed in the Star Line mode; therefore, you will not be able to obtain the desired printing
result.