Software Manual
66
3.6.1. Entering a 2D Code Font (QR Code)
Follow the steps below to describe a QR code.
(1) 2D code type setting
Only describe the parameters to be changed because the default value is set to each setting item.
(2) 2D code data setting
Describe parameters and 2D code data following a 2D code data setting command.
(3) Obtaining 2D code expansion information (Option)
An error notification will be returned if any inconsistencies are detected in the settings made in steps
(1) and (2).
(4) 2D code printing
For information about commands, refer to the separate manual, “STAR Line Mode Command
Specifications".
Example: When generating a 2D code of "012345ABCD " with a QR code (correction rate: 25%):
Description data: E2A0* 012345ABCDP
Description character Setting font Meaning
(1) ‘E2’ QR_CNTL Sets to correct errors level Q (25%).
(2) ‘AO’ QR_CNTL QR Code data setting (Automatic data analysis)
(2) ‘*’ DATA1 QR Code data setting parameter
A = ￥x0A = ‘*’ *１
(2) ‘ ’ DATA1 QR Code data setting parameter
0 = ￥x00 = ‘ ‘ (Space character) *1
(2) ‘012345ABCD’ ESC_FONT 2D code data
(4) ‘P’ QR_CNTL QR code printing
*1 Describe "0A", which indicates the number of bytes (10 bytes) of 2D code data in hexadecimal
notation, in the low-order byte (A) and high-order byte (0) respectively.
Printing result:
To Next Page
Loading...
