Software Manual
124
4.7.7. Sample Application
The sample application performs some demonstration printing but also serves to educate the operator on the
capabilities of the TSP100 futurePRNT in an OPOS application.
To begin the sample application, first select
the device from the drop-down menu. Next
follow the steps below:
1. Click “Open” to open the OPOS device.
2. Click “Claim” to claim the device for
the sample application’s use.
3. Click “DeviceEnabled (True)” to enable
the device for printing.
Click any or all of the following buttons to
print the respective sample:
OPOS Properties Print – Prints a list of the
available OPOS properties and whether or
not they are supported by the TSP100
futurePRNT.
OPOS CharacterSet Print – Prints tables of
each of the available OPOS character sets.
OPOS Methods Print – Prints a list of the
supported OPOS methods.
OPOS ESC Sequences Print – Prints a list
(with examples) of the supported ESC
sequences.
Sample Print – Prints a sample of the
typical point of sale receipt.
To exit the sample application, follow the
steps below:
1. Click “DeviceEnabled (False)” to
disable the device in the application.
2. Click “Release” to make the device
available to other OPOS applications.
3. Click “Close” to close the connection
between the sample application and
OPOS.
Finally, click “Exit” to close the sample
application.
Sample print
Start
End
To Next Page
Loading...
