Software Manual
172
To manually set the IP address, proceed as follows.
1. Open a Command Prompt window.
Windows 10/11: [All Apps] [Windows System/Windows Tools] click [Command Prompt].
Windows7/8.1: At the Windows Start menu, select [All Programs] [Accessories] click
[Command Prompt] .
2. Use the telnet command to connect to the printer you wish to set.
Example: > telnet 192.168.1.84
IP address of the printer you wish to set.
Notes:
You cannot connect to a printer that does not have an IP address. If necessary, set a temporary
IP address for the printer before using telnet.
For instructions, refer to Section 7.3, "Manually Setting a Temporary IP Address."
3. Log into the printer as "root".
The factory default setting for the password is "public".
(If the password has been changed, use the current password.)
To Next Page
Loading...
