Software Manual
107
Caution When using the on demand function, check the following information.
When the on demand function is enabled, the time that the confirmation dialog box appears
may vary according to the printing channel that is used.
The time that the confirmation dialog box appears for each channel is as follows:
Printer Driver
Immediately after a cut
command is sent
OPOS
JavaPOS
WritePrinter API
Immediately after a cut
command is sent (Refer to
following *1 *2)
Virtual Serial Port
Virtual TCP/IC Port
Immediately after a cut
command is sent (Refer to
following *3)
*1) Even if the write data contains several cut commands, the last cut command is recognized
as the trigger and the confirmation dialog box appears. However, when multiple receipts
are sent in a single batch through a virtual serial port, the data will be divided
automatically for processing if it exceeds the buffer capacity. In this case, the cut
command just before the buffer becomes full is the trigger. When using a virtual serial
port, it is recommended to send the data one receipt (data + cut command) at a time.
*2) Even if the write data is sent one line at a time, the confirmation dialog box will not appear
and the data will not be printed until a cut command is received.
*3) Send print data on a page basis (data + Cut command).
Also, select “Yes” or “No” in the confirmation dialog box, and send the next print data.
To Next Page
Loading...
