Software Manual
134
● For TSP100ECO (firmware versions earlier than firmware version 2.0), TSP100IIIW, TSP100IIILAN and
TSP100IIIBI.
(1) Click “Add Port”.
(2) The following window appears.
Enter the port name, and click “OK”.
For Input Port Name, enter the name of the output destination port of the currently used POS
application.
(Example: If the output destination port is named COM3, enter ‘COM3’.
This port is used to erase the interrupted print data when an error is recovered.
(3) Click “Apply Changes” to complete the creation of a virtual serial port.
Notes:
Multiple virtual serial ports can be created, but it is not recommended.
This function is provided to hold the downward compatibility.
To Next Page
Loading...
