Software Manual
18
3) Click [Yes], then open the configure of the printer network settings.
4) Enter the IP Address, Subnet Mask, and click [Apply].
Ask your network administrator about the static IP address and subnet mask to use in
the settings.
5) The settings are saved in the printer, printed, and the connection settings are complete.
Then proceed to Section 1.3.2, "Creating a Printer Queue."
Note: After the printer reset, it may take a short time (perhaps 20 seconds) for the printer to be found
again.
If the printer fails to reappear on the printer list after a noticeable amount of time has passed,
retry the search by clicking again on the [Discovery] button.
To Next Page
Loading...
