Software Manual
94
■ Character Encoding
The default character encoding is "Single Byte Characters".
Selects the character encoding used by the printer. You can select either single-byte encoding (common
for all non-Asian languages) or any of the four available double-byte encodings (for the corresponding
Asian languages).
■ Font Type <ESC/POS mode only>
Standard: (the default): Selects the standard font.
Large: Selects a rounder, bulkier-looking font.
If "Large" is specified for "Font type", a larger text is created based on a font design, and it looks
a little tight because the character space is the same as for the standard font type.
■ Character space (Right) <ESC/POS mode only>
0 (the default) to 3 dots
Use this feature to add extra space (in dot units) to the right of each character. Extra spacing may improve
appearance when you are using the Large font type.
To Next Page
Loading...
