Starline A63 - User Identification by Factory Buttons (Version 4)

StarLine A93, StarLine A63
110
Version 4:
PIN code identication
(pin-code is input by car factory buttons).
This method refers to the authorization when owner input code
sequence. The code sequence — is the sequence of pressing buttons
of standard car (strictly order).
The code sequence PIN1 or PIN2 allows to authorize owner of the
vehicle using standard buttons, possible to detect via CAN bus, with
the possibility of repeatedly pressing each button. The list of your car
available buttons is specied in can.starline.ru
There are two PIN1 and PIN2, which completely replace each
other when authorization needed (in case of owner forgets
one of the codes). It is preferable to use dierent car keys for
PIN1 and PIN2.
For example, if any button used in the PIN1 will break, then it
will be possible to log in using PIN2 code sequence.
If the fault happens with more than one button and
authorization via PIN1 and PIN2 impossible, then you could
login and turn o the engine blocking by using the valet
button. How to turn o the engine blocking and disarm by
valet button see. page 82.
The code sequence PIN1 and PIN2 can be from 3 to 30 press and created
by the car alarms installer. Learn more about creating PIN1 PIN2 code
sequence and see in the installation manual.