StarLine A93, StarLine A63
86
Attention! When learning remote controls all previously
learned remotes are deleted from memory, so all the desired
remote controls should be learned again in the same cycle of
programming (see item 2). Totaly you could learn up to 4
remote controls.
If R2 relay is written in, after learning remote controls must
be restored link of radio relay R2 for this:
- Turn on/o ignition 7 times;
- Press valet button 7 times and switch ignition on. Follow 7
siren signals and wait for 3 light ashes and melodic remote
control signal;
- Switch o the ignition.
Check the quantity of learned remote
controls
With the ignition ON and doors closed, press button 3 of remote
control. Number of LED ashes will correspond to the number of
remote controls, stored in the memory of car alarm.
PIN code emergency disarm
Personal code for emergency disarm or anti-hijack mode
disable may consist of 1, 2 or 3 digits, each of which can take
the value from 1 to 6. The procedure for programming
personal code is described in the installation manual.
Default value (or after reset to factory defaults) personal
code is set to «3» (see function 9, table №1 page 111).
To Next Page
Loading...