Starline A63 - Additional Modules and Anti-Hijack Mode; Anti-Hijack Mode Introduction

StarLine A93, StarLine A63
50
Additional code relays
StarLine R3 and StarLine R4
Code relay StarLine R3 and StarLine R4 are intended for intelligently
control of the hood block and engine block.
Relays connected to the car alarm and controlled by coded signal on
a single-line. This eliminates unauthorized access to the lock of the
hood and engine block.
Connection of GSM modules
If necessary, you can connect to your car alarm one of the additional
GSM modules StarLine M20, M30, M21, M22, M31, M32 or built-in GSM.
The use of GSM module enables you to manage car alarm, receive
messages the invasion of the car to determine location car with
virtually no range limit - wherever there GSM network.
Information and control command transmission occurs through the
channel Communication GSM. Alarm information (triggered alarm
sensors) may be provided to the owner of the phone as SMS-messages
or calls with voice message. Determination of the location the vehicle
is carried out by a base station identier (M20, M21, M22) or GPS +
GLONASS coordinates (M30, M31, M32) sent in SMS messages. It is also
possible to receive SMS with a hyperlink to go to the map section with
indication the location of the vehicle.
Anti-hijack mode
Function 8 table 1
Should be programmed to option 1 or 2
(see page 111).