StarLine A93, StarLine A63
112
If the car starts moving before entering the pin code or at the
time of entry, the engine lock will turn on and alarms will
follow.
Anti-hijack mode
Anti-hijack mode is designed to protect the vehicle from
theft in the case of a robbery in disarmed mode. If the SLAVE
mode, authentication is not used in this case anti-hijack
mode is switch on in standard way – by pressing the remote
control buttons or service button, see page 49. If the tag
authorization is used, car alarm regularly checks the tag is in
the cabin. If tag is absent car alarm automatically block
engine. To activate anti-hijack mode function 8 table №1
should be programmed to option 1 or 2.
Activation of anti-hijack function in SLAVE mode
(user is identified by tag)
While engine is running open (or open and close)
any car door. After this moment car alarm
start to perform specic algorithm
step 1:
after door open starts 60 s
count down to start tag search.
step 2:
tag search (60 s.).
• After 60 since door opened car alarm start to detect tag presence
in car cabin, status LED start to glow constantly. Detection of tag
presence will continue during 60 s.
• If during the rst 30 s tag will not be found, intermittent
(warning) siren and light signals will start.
• If the tag is still not found during next 30 s, engine will be
blocked (see next page).
To Next Page
Loading...