XT6600/6800
20
THE BASICS OF OPERATION
GETTING STARTED
After the treadmill is correctly installed and plugged in, it's time to
start our workout.
Begin by depressing the power switch, located in the front of the
treadmill near the powercord, to the ON position.
SET WEIGHT
After the power switch is depressed to the ON position, the Set
Weight LED will light and the display console will read the last
weight entered from the previous workout. If no weight was previ-
ously entered or the system was reset (refer to the Stop button
information), the Main window will display 150 (factory default).
NOTE: If the Enter button is not pressed within 6
seconds, the system will accept the dis-
played weight and begin a Manual workout
program.
STARTINGAWORKOUT
When you are ready to begin a workout, check that there are no
obstructions near the treadmill. Also confirm there is nothing located
under the treadmill especially if there are children or pets present.
Carefully reach down and press the power switch to the ON posi-
tion. You will hear an audible beep and the Display console will
prompt you to enter your weight. Use the Speed or Incline Arrow
keys to raise or lower the weight value displayed in the LED Matrix
window. Once the desired weight is displayed, press the Enter but-
ton to continue.
To Next Page
Loading...
