XT6600/6800
29
CUSTOM LEARN (1&2)
Do you like to work hard in the beginning of your workout and coast
towards the end.? Or do you like an easy warm-up and gradually
increase the effort level? Create your perfect workout with the
Custom Learn workout.
The first time you use this workout the treadmill will remember or
"learn" your workout profile. As the workout progresses you can
change the speed and the incline and use that customized profile
each time you workout.
After entering your weight the LED next to Manual will be lighted.
Press the Select button until the LED next to CUSTOML EARN 1 or
CUSTOM LEARN 2 is lighted.
Press the Start button to begin Learning or Replay a previously
recorded workout profile.
The treadmill learns 30 segments, each segment is one (1) minute
long and is represented by four (4) LEDs - each LED is 15 seconds
in duration.
Change the speed and/or incline for each segment and the treadmill
memorizes the changes at the very end of that segment. As the
segment progresses and you make a change, the current LED
(blinking orange) marks your progression. As the end of the seg-
ment approaches, the Speed window begins blinking announcing
the changes are being recorded. After the segment ends, the next
segment is ready for your customization.
You can continue over 30 minutes but after the initial 30 minutes the
treadmill will stop recording changes and operate like a regular
manual program - it will not memorize more than 30 minutes.
NOTE: The Pause and Cool Down sessions, if
pressed, will not be memorized for the next
replay of the Custom Learn workout. Only
the Speed and Incline changes are record-
ed.
To Next Page
Loading...
