XT6600/6800
22
CHANGING THE INCLINE
Press the Incline + Arrow button to increase the incline and the
Incline - Arrow button to decrease the incline of the treadmill to the
desired setting. As the buttons are pressed the Incline window will
display the value in "percentage of grade" comparable to the mea-
surement of the grade of a hill.
TIP: The incline may be increased or decreased
at any time during a workout.
PAUSING THE WORKOUT
Press the Stop button to pause your workout temporarily. Pressing
the Stop button once will stop the running belt immediately and retain
all of the current workout information.
When you are ready to continue the workout, straddle the running
belt by holding on to the handrails and placing one foot on each side
of the treadmill. Press the Start button and the belt will slowly begin
to travel. When ready and while holding on to the handrails, carefully
step onto the belt and continue your workout.
THE LAP COUNTER
The Virtual Track in the LED Matrix window will appear when the
Manual program is selected.
The outer LEDs depicts a track to show your progress. This track is
approximately one-quarter mile in length.
A number will appear inside the track to display the number of laps
you complete. The counter starts with "0." Each time you complete a
lap the counter will increase by one. The counter will continue to
increase incrementally, "1, 2, 3, 4…" until you complete 99 laps. The
counter will then restart at "0"
until it reaches "99" where it will again
start at "0."
To Next Page
Loading...
