WARNING — Burn hazard
l Since temperatures within the equipment can reach +60 °C (+140 °F) during
and after operation, take care when opening the lid at the end of a wash cycle.
l Allow sufficient time for items to cool before handling, cleaning, or commencing
maintenance procedures.
l When removing the basket from a full tank of hot water, make sure that gloves
are suitably rated for thermal protection. Alternatively, wait until the water
temperature is below a safe limit for the PPE used.
WARNING — Slipping hazard
l To avoid slippery floors, immediately wipe up any spilled liquid or condensation.
l If spills or leaks contain chemicals, follow the safety precautions and handling
procedures on the chemical label and/or the Safety Data Sheet (SDS).
WARNING — Personal injury and/or equipment damage hazard
l Only the equipment manufacturer or service personnel approved by the
manufacturer may make repairs and adjustments to this equipment.
l This equipment should only be installed, moved, or relocated by a
manufacturer-approved service technician or an approved installer.
l Maintenance performed by unqualified personnel, or installation of unauthorized
parts could cause personal injury, result in improper equipment performance,
invalidate the warranty, or result in serious damage.
l Scheduled preventive maintenance, as described within the service manual, is
required for safe and reliable operation of this equipment. Contact the supplier
to schedule preventive maintenance.
l Failure to perform periodic inspections of the equipment could result in serious
personal injury or equipment damage.
l Do not wear loose fitting clothing, neck ties, or jewelry that could become
entangled in moving parts.
l Never reach into the wash tank when the equipment is operating.
l Always use the basket to process instruments.
4 SAFETY INFORMATION
InnoWave Unity & Unity 20 Operator Manual
To Next Page
Loading...
