3.1 The Touchscreen Display
The touchscreen display is used to adjust wash cycle parameters and to operate the
equipment. The display provides information on equipment settings and activity during
wash cycle operations.
3.2 Screensaver Mode on the Display
If the sonic irrigator is inactive for more than 10 minutes, the display enters the screensaver
mode.
1. To exit the screensaver mode, touch anywhere on the display.
3.3 Entering an Operator PIN (if enabled)
If the equipment has been setup to require an operator authorization code before
operation,
Enter Pin Number
appears after power- on. Operator PIN codes are listed in
Operator and Supervisor Authorization Codes
on page131.
1. When
Enter Pin Number
appears, use the number pad on the display to enter a
valid four-digit operator PIN (personal identification number).
18 USING THE TOUCHSCREEN DISPLAY
InnoWave Unity & Unity 20 Operator Manual
To Next Page
Loading...
Need help?
General
