8.1 Important Safety Information
WARNING - No user-serviceable parts
No user- serviceable parts inside the equipment. To avoid personal injury, improper
equipment performance, invalidation of equipment warranty, or other costly damage,
service and repair should only be performed by service technicians approved by the
equipment manufacturer.
Before performing any maintenance, make sure mains power is disconnected.
All maintenance procedures should be carried out in a well- lit environment,
recommended minimum lighting level is 500 lux (46.5 foot-candle).
Follow recommended safety precautions for cleaning products in use.
It is recommended that Personal Protection Equipment (PPE) is worn during
loading/unloading, and cleaning or decontaminating equipment. This must
include apron, gloves, and eye-protection.
Use non- abrasive cleaners for cleaning internal and external surfaces of
equipment. Follow directions on container and rub in back-and-forth motion in
same direction as surface grain. Abrasive cleaners damage stainless steel.
Cleaner rubbed in circular motion, or applied with wire brush or steel wool will
scratch and dull stainless steel.
In interests of health and safety, all medical washers should be cleaned as part of
routine maintenance program. This will ensure equipment is safe for operators
and maintenance personnel. To keep your equipment operating within design
parameters, the following checks must be performed on regular basis. Please
note that completion of these checks is not substitute for regular servicing and
maintenance by suitably qualified technician.
66 MAINTENANCE
InnoWave Unity & Unity 20 Operator Manual
To Next Page
Loading...
