Revision History
Revision Date Summary
1 02 May 2019 First release
2 05 Aug 2019 Recommended Training moved to Safety Information. General Information
updated. Specification moved to Chapter 9. Installation moved to DOC12354
"InnoWave Unity Installation and Commissioning Manual". Detail added to Loading
of Instruments. Revised Symbols appearing during wash cycle. Maintenance
moved to Chapter 5. Decontamination moved within Maintenance. Terms,
Definitions, and Symbols added to Chapter 10.
3 01 Sept 2020 Unity 20 model variant details added throughout. Disclaimer added to Publication
details. Equipment Identification updated. Manufacturer Information updated.
Recommended Chemicals (outside North America) updated. Chemical intake hose
renamed to chemical pickup. Loading Instrument Basket renamed to Using the
Instrument Basket, and topics expanded. Checks and Maintenance before every
cycle moved to be within Maintenance. On Completion of Wash Cycle rewritten.
Pausing or Aborting Wash Cycle rewritten. Wash Cycle Errors rewritten.
Performing a Full Decontamination updated. Viewing and Editing Wash Program
Parameters rewritten. New chapter on Rewash Feature. Downloading Logs to USB
renamed to Downloading Logs to a USB Flash Drive and rewritten. New chapter on
Wash Programs. Wash Programs removed from Specification. Opening the Unity
20 Lid after a Power Failure added to Troubleshooting. Terms and definitions
updated. Checking the Time and Date Settings added to Maintenance. Dock basket
added to Troubleshooting equipment performance.
4 06 Jun 2021 Added Transportation and Storage details to Safety Precautions. New chapter on
Using the Touchscreen Display. Updated Applied Standards. Corrected procedure
for completion of a rewash cycle. Added note caution on setting long degas and
wash periods within Editing Wash Programs. Added requirement to drain tank in
order to perform Daily Cleaning and Inspection. Corrected disinfectant solution
volume in Performing a Full Decontamination procedure. Added sonic indicators
diagnostics to Troubleshooting Equipment Performance. Soak Cycle program
wash dose corrected. Removed incorrect heat output detail from Environmental
Performance. Updated Terms and Definitions. Corrected supervisor pin detail in
Operator and Supervisor Authorization Codes (Appendix D).
ii
InnoWave Unity & Unity 20 Operator Manual
To Next Page
Loading...
Need help?
General
