i
764333-676
© 2010, STERIS Corporation All rights reserved. Printed in U.S.A.
A Word From STERIS Corporation
Thank you for choosing this fine STERIS product.
STERIS is committed to ensuring your continued
satisfaction. This manual illustrates and identifies
assemblies and components of the System 1E™ Liquid
Chemical Sterilant Processing System. All personnel
involved in the use and maintenance of this
equipment must carefully review and comply with
the S
AFETY PRECAUTIONS and instructions contained
in the Maintenance Instructions (P764333-675). Do not
begin service of this equipment until you have
become familiar with this information.
GENERAL
Assemblies and components of the System 1E Liquid
Chemical Sterilant Processing System are illustrated
and identified on the following pages. The part number,
the description and the quantity required for each usage
are given. Each indentation in the description
represents the assembly level. The UNITS PER
ASSEMBLY column is specific for the given assembly
or subassembly level.
HOW TO USE THE ILLUSTRATED PARTS
BREAKDOWN
1. Determine the function and application of the part
required. Examine the list of illustrations and select
the most appropriate title. Note the illustration page
number.
2. Turn to the page indicated and locate the desired part
on the illustration (see Example 1).
3. From the illustration, obtain the item number
assigned to the part desired. Refer to the
accompanying description for specific information
regarding the part (see Example 1).
4. The abbreviation A/R means “As Required” or
“Amount Required.”
5. The abbreviation SS means “Stainless Steel.”
SPECIAL INSTRUCTIONS
Table 1 provides part numbers and figure references
for the most commonly replaced items on a System 1E
®
Liquid Chemical Sterilant Processing System. This table
is for quick reference only. For a complete listing of
parts, refer to the appropriate Figure and associated
Illustrated Parts Breakdown (IPB) in this Section of the
maintenance manual.
IMPORTANT:
A listing of the
SAFETY PRECAUTIONS
to be observed when operating and servicing
this equipment can be found in
SECTION 1
of
the Maintenance Instructions (P764333-674)
. Do not
operate or service the equipment until you have been trained on this information
.
WARNING – PERSONAL INJURY AND/OR
EQUIPMENT DAMAGE HAZARD: Repairs
and adjustments to this equipment must be
made only by STERIS or STERIS-trained
service personnel. Maintenance performed
by unqualified personnel or installation of
unauthorized parts could cause personal
injury, result in improper equipment
performance, invalidate the warranty, or
result in costly damage. Contact STERIS
regarding service options.
CAUTION – POSSIBLE EQUIPMENT
DAMAGE: To prevent voiding the warranty
or damaging the equipment, use only STERIS
replacement parts.
To Next Page
Loading...
