Steris SYSTEM 1E - Section Description Page

5-2
764333-675
5.2.16. Ambient Temperature Fault ....................................................................................................... 5-14
5.2.17. Lid Open Fault ........................................................................................................................... 5-14
5.2.18. HP Pump Fault........................................................................................................................... 5-14
5.3. Other Faults............................................................................................................................ 5-15
5.3.1. Ground Fault Interrupt (GFI) Trip................................................................................................. 5-15
5.3.2. Water Spills from SYSTEM 1E Processor ................................................................................... 5-15
5.4. Control Faults......................................................................................................................... 5-16
5.4.1. Printer Prints: ROM FAILURE...................................................................................................... 5-16
5.4.2. Printer Prints: RAM FAILURE ...................................................................................................... 5-16
5.4.3. Printer Prints: RTC FAILURE....................................................................................................... 5-16
5.4.4. Printer Prints: TC1 FAILURE ....................................................................................................... 5-16
5.4.5. Printer Prints: TC2 FAILURE ....................................................................................................... 5-16
5.4.6. Printer Prints: TC3 FAILURE ....................................................................................................... 5-17
5.4.7. Printer Prints: CHM-PRES NOT CALIBRATED........................................................................... 5-17
5.4.8. Printer Prints: INLET NOT CALIBRATED.................................................................................... 5-17
5.4.9. Printer Prints: OUTLET NOT CALIBRATED................................................................................ 5-17
5.4.10. Printer Prints: DRN-BLK NOT CALIBRATED ............................................................................ 5-17
5.4.11. Printer Prints: CONC. NOT CALIBRATED................................................................................. 5-17
5.4.12. Printer Prints: FLASH VALUES RESTORED............................................................................. 5-17
5.4.13. Printer Prints: FLASH VALUES SAVED .................................................................................... 5-18
5.4.14. Printer Prints: FLASH VALUES LOST. PLEASE REPROGRAM............................................... 5-18
5.4.15. Printer Prints: **LOW BATTERY** PLEASE REPLACE ........................................................... 5-18
5.4.16. Printer Prints: KEY X ERROR ................................................................................................... 5-18
5.5. Cable/Harness Pin Outs ........................................................................................................ 5-18
NOTE: For additional troubleshooting reference:
• Use the SYSTEM 1E Liquid Sterilant Processing System service electrical schematic (P762650-985,
located in the
REFERENCE DRAWINGS section) for system pin and pin-out references.
• Specific cable and wire harness pin outs are illustrated in S
ECTION 5.5, CABLE/HARNESS PIN OUTS, ON
PAGE
5-18 and are referenced in troubleshooting steps where applicable.
Section Description Page