WORKSHOP MANUAL
Map of functional units
MP 84/98 - MP 84/98 Hy
number must always be quoted when requesting
spare parts or any information from the Manufac-
turer.
3) Engine
The engine is made to precise technical specica-
tions which dierentiate it from similar items by this
same Manufacturer.
The serial number on the label clearly identies
the product and its specications. This number
must always be quoted when requesting spare
parts or any information from the Manufacturer.
B) Guarantee validity
The guarantee is supplied under the terms and the
limits of the contractual relations in being. As far as
the engine and the transmission unit are concerned,
the conditions given by their respective manufactur-
ers apply.
A) Identification
1) Machine
Each machine has a label attached (1) under the dri-
ver’s seat which shows the technical specications,
the model and the serial number..
The model and serial number must be shown on
each repair sheet when requests are made un der
guarantee, and are indispensable for spare part
orders.
2) Transmission
The transmission unit (both mechanical and hydro-
static) is made up of an engine block including the rear
axle. This unit is made by another manufactu rer to our
precise technical specications which die rentiate it
from similar items by this same Manufacturer.
The serial number on the label (2) clearly iden-
ties the product and its specications. This
CHAPTER REVISION FROM ... PAGE
1.1 0 2018 1 of 2
IDENTIFICATION AND PROCEDURES
General informations
This chapter covers all the main aspects of the
re la tionship between the Manufacturer and the
Ser vice Centres.
A close collaboration between the Manufacturer
and the Service Centres is conclusive for solv
ing pro blems in the most eective way as well as
main taining an image of eciency and reliability.
Compliance with these brief and simple guide
lines will facilitate this task and prevent general
misunderstandings and timewasting for both the
manufacturer and the service centre.
Related topics
---
1
2