WORKSHOP MANUAL
Map of functional units
MP 84/98 - MP 84/98 Hy
Rimove the nuts (8) and (9), the cup washer (10) and
(11), the guide (12) and dismantle the ring gear (13).
In the case of replacement of the ring gear and pi nion,
the blocks (14) and (15), that might have been placed
under the ring gear previously, must be re mo ved.
Check pin (16) and (17) wear and, if necessary re-
pla ce them by unscrewing the relevant nuts (18) and
(19).
To assemble, perform the operations described a bove
in reverse order being careful to correctly re connect
the pin (5) in the pinion housing (4).
When replacing the pins (16) and (17), tighten the re-
levant nuts (18) and (19) to the recommended value.
Remove the inspection hatch (1)..
A) Dismantling the steering pinion and ring gear
Unhook the spring (2) and lift the steering column (3)
just enough to be able to draw out the pinion (4), tak-
ing care not to take out the pin (5).
Unscrew the nut (6) and disconnect the steering tie-
rod (7).
General informations
Related topics
[
4,7] Steering geometry adjustment
Tightening torques
6 Steering tie-rod fastening nut ......... 45 ÷ 50 Nm
18-19 Pin fastening nuts ................... 25 ÷ 30 Nm
DISMANTLING OF THE STEERING
COMPONENTS
CHAPTER REVISION FROM ... PAGE
6.3 0 2018 1 of 2
3
4
2
6
5
7
1
9
8
11
10
12
13 14 15
16 17
19
18
To Next Page
Loading...
