Stihl FSA 90 - Switching Off Procedure; Stopping the Tool Safely

FSA 90, FSA 90 R
English
58
Full Harness
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N Balance the machine – see
"Balancing the Machine".
The type and style of the harness and
carabiner (spring hook) depend on the
market.
Attaching Machine to Harness
N Attach the carabiner (1) to the
carrying ring (2) on the shaft.
Floating Position
N The cutting attachment should just
touch the ground.
The correct floating position is obtained
as follows:
Balancing the Machine
N Loosen the screw (3).
N Move the carrying ring (2) up or
down the shaft – tighten the screw
moderately – let the machine go and
wait until is its balanced – then
check the floating position.
When the correct floating position has
been reached:
N Tighten down the screw on the
carrying ring firmly.
Detaching Machine from Harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
3988BA018 KN
2
1
Balancing the Machine
1
2
1
2
002BA387 KN
3988BA019 KN
3
2
002BA390 KN
1
2
1
2
002BA391 KN