FSA 90, FSA 90 R
English
51
N Position the deflector against the
motor housing.
N Push hooks (3) on deflector into the
recesses in the motor housing.
N Insert the screw (4) and tighten it
down firmly.
Placing Power Tool on the Ground
N Move the retaining latch to ƒ and
remove the battery.
N Position your power tool so that the
cutting attachment mounting face is
pointing up.
Mounting the Fanwheel
The machine comes standard with a
fanwheel.
N Push the fanwheel (1) onto the
shaft (2).
NOTICE
The fanwheel is necessary for mounting
cutting attachments.
Mounting Hardware for Cutting
Attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
Machine supplied without mounting
hardware
Only mowing heads may be used which
mount directly to the shaft (2).
Mounting the Cutting
Attachment
To Next Page
Loading...
