FSA 90, FSA 90 R
English
59
Throwing Off the Machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger. To
throw off the machine, use the
procedure described under "Detaching
Machine from Harness". Practice
removing and putting down the power
tool as you would in an emergency. To
avoid damage, do not throw the power
tool to the ground when practicing.
Controls
1 Trigger switch lockout
2 Trigger switch
3 Retaining latch with positions ‚
and ƒ
4 Set wheel – limits travel of trigger
switch – see "Function of set wheel".
Function of set wheel
The set wheel (4) enables the travel of
the trigger switch to be preset for any
motor speed:
– Turn the set wheel (4) in direction of
– for shorter trigger switch travel and
a reduced motor speed.
– Turn the set wheel (4) in direction of
+ for longer trigger switch travel and
a higher motor speed.
– You can override the preset stop by
pulling the trigger switch firmly to
accelerate the motor up to
maximum speed – the preset stop
remains unaffected. The original
setting is restored when the trigger
switch is released.
Fitting the Battery
A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
N If necessary, remove the cover from
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Switching On
To Next Page
Loading...
