FSA 90, FSA 90 R
English
67
Battery
The machine may be operated only with
original STIHL AP and AR rechargeable
batteries.
Power tool running time is dependent on
the energy content of the battery.
Length
Weight
Noise and Vibration Data
Noise and vibration data are determined
on the basis of the rated maximum
speed.
For further details on compliance with
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
Sound pressure level L
p
to EN 786
Sound power level L
w
to EN 786
Vibration measurement a
hv
to EN 786
The K-factor in accordance with
Directive 2006/42/EC is 2.5 dB(A) for
the sound pressure level and sound
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
2
for the vibration measurement.
The vibration values quoted above have
been measured according to a
standardized test procedure and may be
used to compare electric power tools.
Depending on the type of usage, the
vibrations that actually occur may differ
from the values quoted.
The vibration values quoted may be
used for an initial assessment of the
user's exposure to vibrations.
The actual exposure to vibrations has to
be evaluated. This process may also
take into account times during which the
electric power tool is switched off and
times during which it is switched on but
running without load.
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
by road transport to the place where the
machine is to be used without additional
requirements.
The lithium ion batteries included are
subject to the provisions of the
legislation relating to dangerous goods.
When shipped by a third party (e. g. air
transport or haulage firm), special
packaging and identification
requirements must be observed.
Specifications
Type: Lithium-ion
Designation: AP, AR
without cutting
attachment
1774 mm
(69.8 in)
without battery, with cutting attachment
and deflector
FSA 90: 3.2 kg
(7.1 lbs)
FSA 90 R: 2.8 kg
(6.2 lbs)
FSA 90
with mowing head: 83 dB(A)
with metal cutting
attachment: 73 dB(A)
FSA 90 R
with mowing head: 83 dB(A)
with metal cutting
attachment: 73 dB(A)
FSA 90
with mowing head: 92 dB(A)
with metal cutting
attachment: 84 dB(A)
FSA 90 R
with mowing head: 92 dB(A)
with metal cutting
attachment: 84 dB(A)
FSA 90
Handle, left Handle, right
with mowing
head: 3.5 m/s
2
3.5 m/s
2
with metal
cutting
attachment: 1.0 m/s
2
1.0 m/s
2
FSA 90 R
Handle, left Handle, right
with mowing
head: 4.8 m/s
2
3.5 m/s
2
with metal
cutting
attachment: 1.4 m/s
2
1.4 m/s
2
To Next Page
Loading...
