Stihl MS 461 - Page 69

68 MS 461, MS 461-R
: Push the wires into the guide
(arrow) – the thin wire must be
under the thick wire.
– To ensure the wire is not twisted
during installation, hold the
heater switch with its slot facing
the throttle trigger.
: Fit the grommet (1) on the wire,
push the connector sleeve (2)
into the heater switch (3) as far
as stop.
– Push the grommet onto the
heater switch.
3443RA236 TG3443RA373 TG
2 31
: Push the heater switch (1) from
inside the carburetor box through
the ground wire's contact ring
and the hole in the tank housing
so that the slot (2) is horizontal
and points in the direction of "0".
: Hold the heater switch (1) in that
position, fit the washer, then the
nut (2) and tighten it down firmly.
0
2
3443RA374 TG
1
3443RA375 TG
2
1
: Push the wire (1) to heater
switch (2) into the guides
(arrows).
– Install the tank housing,
b 12.9.3
– Reassemble all other parts in the
reverse sequence.
3443RA234 TG
1
2