Stober SD6 - Website Downloads; Technical Support; About this Manual

ID 442710.00 5WE KEEP THINGS MOVING
General Information
1
Operation manual PROFINET
1.2 Website downloads
Information about PROFINET
You can find general information about PROFINET on the "PROFIBUS &
PROFINET International (PI)" website (www.profibus.com).
You can find PROFINET-specific directives, profiles, presentations, brochures
and software in the associated download area 
(see http://www.profibus.com/pi-organization/regional-pi-associations/
germany/downloads/).
SD6 – Device description
You can get a GSD file for simple integration of the STOBER drive controller in
the respective system environment at www.stoeber.de
.
Information about the Siemens TIA portal
You can get the most important information about the Siemens TIA Portal as
well as extensive documents, links and training at 
www.siemens.de/tia-portal/details
.
1.3 Technical support
If you have technical questions that are not answered by this document, please
contact:
• Phone: +49 7231 582-3060
• E-mail: applications@stoeber.de
If you have questions about training sessions, please contact
training@stoeber.de.
1.4 About this manual
This documentation supports you with the assembly and connection of the
PN6A communication module to connect a SD6 drive controller (IO device) via
the PROFINET IO bus system to a PLC as IO controller.
The commissioning of IO device and IO controller is described on the Siemens
SIMATIC S7-1500 controller as an example. The systems are configured with
the aid of the STOBER Software DriveControlSuite DS6 as well as the
Siemens Engineering Framework TIA Portal.
Special knowledge
To be able to put the PN6 communication module into operation as part of a
SD6 drive controller in combination with the S7-1500 controller, you should be
familiar with the basics of PROFINET and PROFINET IO.
Technical requirements
Before putting the PN6 communication module into operation, you must first
wire the SD6 drive controller and initially check it is functioning correctly. To do
this, follow the commissioning instructions of the SD6 drive controller.