93 B58FZS 0000000078 EN 002
TROUBLESHOOTING
7 Troubleshooting
⚠ WARNING
Mortal danger and material damage due to lack of safety!
Troubleshooting and repair work carried out incorrectly can impair the safety of the front loader.
Necessary repair work should only be performed by an authorised specialised workshop.
Faults on the front loader are frequently caused by factors that are not a result of a malfunction on the
front loader.
In case of faults, first check:
Is there enough oil in the hydraulic tank of the tractor?
Has the correct oil been used?
Only use oil types specified in the tractor operating instructions. The wrong oil can cause foam to
build up and leaks.
Is the hydraulic oil clean and free of moisture?
You may need to change the oil and filter.
Install an additional filter in the hydraulic system if necessary.
Are the hoses and connections mounted correctly?
The connections must be locked in place.
Are the hoses and connectors undamaged, not clamped or twisted?
Have the cylinders of the front loader been moved several times into their end positions to remove
the air from the lines and the cylinders?
Have you taken the low outside temperatures into consideration?
Is the oil at operating temperature already?
If these points do not resolve the problem, the following table will help to localize and correct the fault.
Incorrect repairs can lead to safety risks. That is why the repair work must only be carried out by
suitably qualified personnel!
STOLL recommends that the repair work be performed at a specialised workshop.
To Next Page
Loading...
