Stratasys FDM 2000 - Page 15

Contents
FDM 2000/3000/8000 Manual
10 MAY 01
F2/3/8000-iv
Changing the FDM Tip____________________ F2/3/8000-24
Removing an FDM Tip From the Head _ F2/3/8000-24
Attaching FDM Tips to the FDM Head _ F2/3/8000-25
Changing Spools of Modeling Material______ F2/3/8000-27
Removing an Empty Spool of Material _ F2/3/8000-27
Removing a Mounted Spool of Material F2/3/8000-27
Mounting a Spool of Material _________ F2/3/8000-27
Enabling the Auto Shutoff_________________ F2/3/8000-29
Dry Filament Measurement Procedure ______ F2/3/8000-30
Drying P400 ABS Filament ____________ F2/3/8000-30
Replacing the Foam Foundation____________ F2/3/8000-31
Removing the Foundation ____________ F2/3/8000-31
Attaching the Foundation_____________ F2/3/8000-31
Positioning the FDM Head ____________ F2/3/8000-33
FDM 2000/3000/8000 Maintenance
Maintenance_____________________________ F2/3/8000-35
Equipment Required _________________ F2/3/8000-35
Cleaning the FDM Head __________________ F2/3/8000-36
Daily Cleaning ___________________________ F2/3/8000-38
Periodic Maintenance_____________________ F2/3/8000-39
Checking the Operation of the Filament SensorF2/3/8000-39
Cleaning and Lubricating the Lead Screws __ F2/3/8000-40
FDM 2000/3000/8000 Troubleshooting
Torque Limiting__________________________ F2/3/8000-42
FDM 2000/3000/8000 Reference
FDM 2/3/8000 Concepts __________________ F2/3/8000-44
Fused Deposition Modeling ___________ F2/3/8000-44
FDM 2/3/8000 Descriptions _______________ F2/3/8000-45
Control Panel _______________________ F2/3/8000-45
Keypad Display Messages_____________ F2/3/8000-48
Hardware___________________________ F2/3/8000-50
Index