Stratasys FDM 2000 - FDM 2000;3000;8000 Maintenance; Equipment Required

Procedures
®
F2/3/8000-35
10MAY01
Maintenance— Equipment Required
FDM 2000/3000/8000
Maintenance
Equipment Required
The following equipment is required for maintenance of the Stratasys FDM 2000/
3000/8000. Some of these items are included in your start-up kit.
• Phillips head screwdriver
• small flat-head screwdriver
• plastic putty knife
• small nylon brush
• small brass brush
• cotton swabs (e.g. q-tip)
• household counter-top cleaner
• plexiglass cleaner for front door
• combination wrench for leveling the cabinet
• hand shop brush
• soft shop rags
• lightweight spindle oil
• pair of heat resistant gloves
• Allen wrench set
• new tip wrench for FDM tips
• tool for unscrewing the seal inside the head
• tweezers
• dental mirror
• 10x magnifying glass
• sharp clipper for clipping material
Stratasys’ minor repair tool kits and finishing kits are sold separately.