Stratasys FDM 2000 - Section 1; Table of Contents

Contents
®
F2/3/8000-iii
10 MAY 01
Contents
Introduction
About This Manual ________________________ F2/3/8000-2
Purpose______________________________ F2/3/8000-2
Organization _________________________ F2/3/8000-2
Conventions _________________________ F2/3/8000-2
About the FDM 2/3/8000 __________________ F2/3/8000-5
Process Overview _____________________ F2/3/8000-5
FDM 2/3/8000 _______________________ F2/3/8000-5
New Features ________________________ F2/3/8000-6
Materials ____________________________ F2/3/8000-7
BASS ____________________________________ F2/3/8000-8
Support Sets ______________________________ F2/3/8000-9
Finishing the Part _________________________ F2/3/8000-9
Capabilities______________________________ F2/3/8000-11
Requirements ____________________________ F2/3/8000-11
Installation ______________________________ F2/3/8000-11
FDM 2000/3000/8000 Procedures
Calibration ______________________________ F2/3/8000-13
Downloading Buttons_________________ F2/3/8000-13
Toolpath Width Calibration ___________ F2/3/8000-15
T12 and T16 Tip Offset Calibration _____ F2/3/8000-16
T10 Tip Offset Calibration_____________ F2/3/8000-17
Creating a Calibration Box ____________ F2/3/8000-18
FDM 2000/3000/8000 Usage
FDM Modeling Operations ________________ F2/3/8000-19
Changing the FDM Head _____________ F2/3/8000-20
Removing an FDM Head from the FDM F2/3/8000-20
Attaching an FDM Head______________ F2/3/8000-22
Removing Backflow from the Head ____ F2/3/8000-23
Setting Modeling Temperatures _______ F2/3/8000-24