Figures
v
Figures
Figure 1-1. ftServer 2600, 4500, and 6300 Systems 1-2
Figure 1-2. ftServer 2600, 4500, and 6300 Systems: Front View 1-4
Figure 1-3. ftServer 2600, 4500, and 6300 Systems: Rear View 1-5
Figure 1-4. CPU-I/O Enclosure: Interior Components, Model 2600 1-6
Figure 1-5. CPU-I/O Enclosure: Interior Components, Models 4500
and 6300 1-7
Figure 3-1. System Front Panel LEDs 3-4
Figure 3-2. CPU-I/O Enclosure LEDs and Buttons (Bezel Removed) 3-6
Figure 3-3. Hard Disk Drive LEDs 3-10
Figure 3-4. Ethernet and VTM Ports: Status LEDs 3-13
Figure 3-5. Modem Assembly: Status LEDs 3-15
Figure 3-6. PDU Status LEDs 3-17
Figure 4-1. Shipping Impact Indicators 4-2
Figure 5-1. Replacing the System Bezel 5-5
Figure 5-2. Replacing the Front Panel 5-7
Figure 5-3. Disconnecting a CPU-I/O Enclosure 5-9
Figure 5-4. Loosening the Front Release Levers on an Enclosure 5-10
Figure 5-5. Disengaging the Safety Lever on an Enclosure 5-11
Figure 5-6. Aligning the CPU-I/O Enclosure 5-13
Figure 5-7. Engaging the Release Levers on an Enclosure 5-14
Figure 5-8. Removing an Enclosure Cover 5-16
Figure 5-9. Replacing an Enclosure Cover 5-17
Figure 5-10. Replacing the Plenum 5-19
Figure 5-11. Replacing the System Backplane Assembly 5-22
Figure 5-12. DIMM Slot Numbering in Single-Processor Systems
(Viewed from Front) 5-25
Figure 5-13. DIMM Slot Numbering in Dual-Processor Systems
(Viewed from Front) 5-26
Figure 5-14. DIMM Ejector Levers 5-28
Figure 5-15. Replacing the CPU-I/O Enclosure Fan Assembly 5-31
Figure 5-16. Removing the Power Supply Fan 5-33
Figure 5-17. Replacing a Power Supply Fan 5-34
Figure 5-18. Removing the PCI Adapter Bracket 5-36
Figure 5-19. Removing the PCI Adapter from the PCI Slot 5-37
Figure 5-20. Removing the PCI Bulkhead Bracket Screws 5-39
Figure 5-21. Loosening the Captive Screw on the Motherboard 5-40
Figure 5-22. Removing the Bracket from the PCI Riser Assembly 5-41
To Next Page
Loading...
