EasyManua.ls Logo

Stryker FLUID SAFE - Page 16

Stryker FLUID SAFE
222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Purpose of the Device
8
EN
Filling of the tube and resetting the display are to be done at the doctor’s
discretion. When using the balancing system, follow the exact operating
instructions in this manual. Should the pump be used without the balancing unit
for diagnostic purposes, the corresponding handbook is to be consulted without
fail.
The deficit and inflow values are lost in case of a power loss or „brownout“.
Please pay attention that the containers hang freely and are not supported or in
contact with anything from below, otherwise the weight necessary for
balancing cannot be accurately ascertained.
Do not use this device if a defect is suspected or detected during the function
check. This also applies to obvious defects, especially defects and damage of the
power plug and power cable.
Electrical interference
Electrical interference with other devices or instruments was practically
eliminated when developing this devices and none was detected during testing.
However, if you still detect or suspect such interference, please follow these
suggestions:
• move this,
• the other, or both devices to a different location
• increase distance between used devices
• consult an electro-medical expert.
DANGER
DANGER
DANGER
DANGER
WARNING

Table of Contents

Related product manuals