Stryker FLUID SAFE - Inserting the Tube Set Correctly

Operating the Device
20
EN
5.3 Inserting the Tube Set
(See Fig. 5-5) The tube set consists of three tube sections (1), (3) and (5), a
pressure chamber (6), one tube fastener (2), and two insertion spikes (8). The
tube sections are designated irrigation (3), roller (1), and instrument tube (5).
The tap spikes are used to connect the tube sections with the bags (9).
Inserting the Roller Tube Inserting the roller tube is depicted in Fig. 5-6.
When inserting the roller tube, make sure not to damage the membranes (7)of
the pressure chamber. Insert the pressure chamber (6) only if not pressurized.
(1)
(3)
(8)
(9)
(2)
(5)
(6)
(4)
(7)
Fig. 5-5 Inserting the tube set
(1) Roller tube
(2) Tube fastener
(3) Irrigation tube
(4) Nose
(5) Instrument tube
(6) Pressure chamber
(7) Membranes
(8) Tap spikes
(9) Fluid bags
B
A
(1)
(7)
(6)
(5)
(4)
(3)
(2)
Fig. 5-6 Position the roller tube
(1) Roller tube
(2) Tube fastener
(3) Irrigation tube
(4) Nose
(5) Instrument tube
(6) Pressure chamber
(7) Membranes