Stryker FLUID SAFE - Page 31

Operating the Device
23
EN
To set values:
•Use the ▲/▼ keys (12) for the nominal pressure.
•Use the ▲/▼ keys (8) for the nominal flow.
To change the display:
• In increments of 5-> by pressing the key briefly
• In increments of 10-> when pressing the key longer
At the display unit(See Fig. 5-9) All LED’s of the display unit are switched on almost simultaneously
with the displays of the pump unit for a performance test.
Afterwards you will see:
Deficit display (16) -> 0
Inflow volume display (17) -> 0
Deficit bar graph (20) -> the upper first segment and the loss rate alarm icon
(19) is illuminated.
Fig. 5-9 Messages of the display unit
FLUID SAFE Fluid Management
Systems
(16) Deficit display
(17) Inflow volume display
(18) Reset key
(19) Deficit rate alarm icon
(20) Deficit bar graph
(16)
(17)
(18)
(19)
(20)