14 6082-209-001 REV A www.stryker.com
Return To Table of Contents
Setup Procedures
Unpack the cartons and check all items for proper operation. It is important that the cot is working properly before it
is put into service. Have a qualified service person use the following list and the operation instructions to check the
cot before it is put into service.
Note: Ensure that all shipping and packaging materials have been removed from the product(s) prior to use.
• All fasteners secure (reference all assembly drawings)
• All welds intact, not cracked or broken
• No bent or broken tubing or sheet metal
• No debris in wheels
• All wheels secure, rolling and swivelling properly
• Siderails move and latch properly
• Backrest operating properly
• Optional accessories intact and operating properly
• Height positioning latch functioning properly
• Cot secure in each height position
• Undercarriage folds properly
• Breakaway head section operating properly
• Safety bar operating properly
• Foot rest operating properly
• No rips or cracks in mattress cover
• Body restraints intact and working properly
• Wheel lock(s) operating properly (optional equipment)
• Does the vehicle safety hook engage the safety bar so that the cot loads and unloads easily from the vehicle?
• Is there an approved crash−stable fastener (Stryker part number 6370/6377/6378 or 6371 − not included) installed
in the vehicle?
The patient compartment of the vehicle in which the Cot will be used must have:
• A smooth rear edge for cot loading.
• A level floor large enough for the folded cot.
• Stryker 6370/6377/6378/6379 or 6371 crash stable cot fastener (not included).
• 32” (81 cm.) maximum loading height.
• Space to install the safety hook.
When necessary, modify the vehicle to fit the cot. Do not modify the cot.
WARNING
Do not modify the cot. Modifying the cot can cause unpredictable operation resulting in injury to the patient or operator.
Modifying the cot will also void its warranty (see page 10).
To Next Page
Loading...
Need help?
General
