www.stryker.com 6082-209-001 REV A 31
Return To Table of Contents
Cot Operations
CHANGING THE COT HEIGHT WITH TWO OPERATORS
Figure 24 - Release Handle Locations
Note: Changing the height while a patient is on the cot requires a minimum of two operators, positioned at both ends
or on each side of the cot. Each operator must grasp the cot frame securely.
To lower the cot from the ends, the operator at the foot end of the cot positions his/her hands so the release handle
(A or B) can be squeezed while a secure grip is maintained on the lifting bars. Both operators must lift the cot until
the weight is off the latching mechanism (approximately 1/4”). The operator at the foot end squeezes and holds the
release handle and both operators then raise or lower the cot together. The handle is released when the desired
position is reached. Both operators should maintain a secure grip on the litter frame until the latching mechanism is
securely locked into position.
To lower the cot from the sides, the operator on the patient’s right positions his/her hands so he/she can reach the
release handle at the midpoint of the litter (C). Both operators must lift the cot until the weight is off the latching
mechanism (approximately 1/4”). The operator at the patient’s right squeezes and holds the release handle. Both
operators then raise or lower the cot together. The handle is released when the desired position is reached. Both
operators should maintain a secure grip on the litter frame until the latching mechanism is securely locked into position.
WARNING
Grasping the cot improperly can cause injury. Grasp only the litter frame or the lifting bar to lift the cot. Keep hands,
fingers and feet away from moving parts. To avoid injury, use extreme caution when placing your feet near the base
tubes while raising and lowering the cot.
A
FOOT END
C
B
To Next Page
Loading...
Need help?
General
