20
S
6.2 Cleaning the Wall Control
The surface of the wall control can be cleaned using a damp, non-abrasive cloth. Using a mild soap and
water solution, dampen the cloth and wipe the surface of the wall control until clean.
6.3 Cleaning Compatibility of the HD Camera System
Caution
Professional Amphyl II Disinfectant Spray should not be used to disinfect or clean the HD Camera
because it can cause fade the HD Camera logo.
Note: Amphyl II Disinfectant Spray can be used on the decoder assembly.
The surface of the HD Camera System components can be cleaned using the following:
• Isopropyl alcohol
• Quaternary ammonium
• Soap and water solution
• Bleach & water solution
6.4 Cleaning and Sterilizing the Sterilizable Handle and Camera Covers
Warning
Sterilizable handle covers and sterilizable camera covers are shipped non-sterile. For the safety of
medical personnel and patients, clean and sterilize sterilizable handle covers and sterilizable camera
covers prior to use.
Limitations on Reprocessing
The sterilizable handle covers should be replaced after 260 sterilization cycles. The sterilizable aluminum
camera cover should be replaced after 390 sterilization cycles.
Instructions for Sterilizable Handle
Point of Use Wipe excess soil from the sterilizable handle cover using disposable paper
towels.
Containment and
Transportation
Reprocess the sterilizable handle cover as soon as reasonably practical
following use.
To Next Page
Loading...
Need help?
General
