44
C7000IOC
EN/09.2017/G44 © STULZ GmbH – all rights reserved
cybercool indoor chiller original instructions
Electrical box
Main switch
Control fuses
Power
switches
Controller C7000Advanced
Terminal, Start/stop-key
Chiller with C7000Advanced Terminal:
• familiarize yourself with the operation of the C7000 con-
troller. To do this, there is a separate manual.
• adjust the desired water temperature at the controller.
Chiller without C7000Advanced Terminal:
• open the electrical box door with the main switch
switched on.
• connect a notebook at the service port X15 on the
C7000IOC board, to carry out possible configurations
(setting the setpoint).
• shut the electrical box door.
To Next Page
Loading...
