EasyManua.ls Logo

Subaru 602 - Keyless Entry

Subaru 602
162 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
64
June 2013
Electrical Systems Operation & Diagnosis Module (602)
Keyless Entry
Function of Keyless Entry System
Keyless Transmitter 2011 Forester TPMS and Keyless Entry
Control Unit
Function Function method Action on a vehicle Answer back
Locking the doors Press the Lock button once. All doors lock. The hazard asher blinks once
and the buzzer sounds once (if
all the doors were closed when
the Lock button was pressed).
The hazard asher blinks 5
times and the buzzer sounds 5
times (if any of the doors were
open when the Lock button
was pressed).
Unlocking the doors The rst time: Press the Unlock
button once.
Only the driver’s door
unlocks. (*1)
The hazard asher blinks twice
and the buzzer sounds twice.
The second time: Press the
Unlock
All doors unlock.
Unlocking the trunk lid Press and hold the Trunk lid/
Rear gate button for at least 2
seconds
Only the trunk lid unlocks. The hazard asher blinks twice
and the buzzer sounds twice.
Unlocking the rear
and gate.
Press the Trunk lid/Rear gate
button once.
Only the rear gate un-
locks.
The hazard asher blinks twice
and the buzzer sounds twice.
Panic alarm Press the Panic button once. The horn sounds and
the hazard asher blinks
continuously.
Stopping the panic
alarm
Press any button once. The horn stops sound-
ing and the asher stops
blinking.
Buzzer ON/OFF (1) Press the Unlock button
once.
The buzzer setting switch-
es from ON to OFF.
The hazard asher blinks twice
and the buzzer sounds twice.
(2) Simultaneously press and
hold both the Lock and Unlock
buttons for at least 2 seconds.
The buzzer setting switch-
es from OFF to ON.
The hazard asher blinks once
and the buzzer sounds once.
Vehicle nder function Press the Lock button 3 times in
succession within 5 seconds.
The horn sounds once and
the hazard asher blinks
3 times.
Conrming that doors
are closed.
(1) Press the Lock button once
when a door is open.
(2) Close all the doors.
All doors lock. The hazard asher blinks once
*1: If any of the doors are open when you press the Unlock button (even for the rst time), all the door
will unlock.
111
112

Table of Contents

Related product manuals