Subaru 602 - How To Register the Transmitter

65
June 2013
Electrical Systems Operation & Diagnosis Module (602)
How To Register the Transmitter
Using the Subaru Select Monitor
1) Make a note of the ID number. A label
showing the ID number is affixed either
to the bag containing the transmitter or
the circuit board inside the transmitter.
Bag (ID Number)
Open Transmitter
2) Connect the Subaru Select Monitor
(SSMIII) to the vehicle.
3) Turn the ignition switch to the ON position.
4) Operating the SSMIII as described below.
System Selection Menu
113
114
115