Subaru 602 - Page 66

66
June 2013
Electrical Systems Operation & Diagnosis Module (602)
INTEG. UNIT Mode Failure Diag.
ID Input
ID Input
5. Use the [ ] key or the [
] key on the
SSMIII to change the number, and then
use the [
] key or the [ ] key to move
to the next digit.
ID Confirmation
ID Complete
6) Confirm the displayed number with the
number recorded in step 1.
7) Press “yes” to enter another transmitter
code. Press “no” to end the procedure.
A maximum of four transmitters can be
registered to a single vehicle.
Note: Press and hold a button on the
transmitter after programming
to complete the registration
process.
NOTE: Go to page 140 of Supplemental
information for Keyless Entry
Registration of newer vehicles.
116
117
118
119
120